I am wondering about the speed as show in the network connection information, e.g. 100Mb/s, 10Mb/s, not the available bandwidth. Thanks in advance!
programatically read this info and parse it, looking for 100baseTx or similar
# mii-tool -v eth0 eth0: negotiated 100baseTx-FD flow-control, link ok product info: vendor 00:00:20, model 32 rev 1 basic mode: autonegotiation enabled basic status: autonegotiation complete, link ok capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD advertising: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD flow-control link partner: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD flow-control
also, on same article you could use this and look for the “speed:” line
#ethtool eth0 Settings for eth0: Supported ports: [ TP MII ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Supports auto-negotiation: Yes Advertised link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full Advertised auto-negotiation: Yes Speed: 100Mb/s Duplex: Full Port: MII PHYAD: 32 Transceiver: internal Auto-negotiation: on Supports Wake-on: pumbg Wake-on: p Current message level: 0x00000007 (7) Link detected: yes
Answered By – John Boker
Answer Checked By – Willingham (BugsFixing Volunteer)